You must perform a Passlockâ„¢ Learn Procedure if any
of the following components have been replaced:
| • | Vehicle control module |
Both of the above modules except for the Passlockâ„¢ sensor must
be programmed using their own vehicle configuration. See the individual module
service manual section.
There are 2 types of Passlock learn procedures:
| • | A 10 minute procedure which requires a Techline Terminal
and a Tech 2 scan tool. This procedure is listed below: |
10 Minute Procedure
- Ensure that the battery is fully charged.
- Follow the directions provided on the Techline Terminal and the
Tech 2.
