Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Is the measurement greater than 1.0 volt? | 1.0 volt | Go to Step 6 | Go to Step 3 |
3 | Check for a poor connection at connector C211, or for an open circuit condition in the pigtail to the wiper/washer switch assembly. Is a poor connection condition or an open circuit condition present? | -- | Go to Step 5 | Go to Step 4 |
4 | Replace the wiper/washer switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle . Is the replacement complete? | -- | -- | |
5 | Repair the poor connection condition or the open circuit conditon. Is the repair complete? | -- | -- | |
6 | Backprobe from the wiper/washer switch connector C211, terminal E5 to ground, using a DMM. Is the measurement greater than 1.0 volt? | 1.0 volt | Go to Step 7 | Go to Step 3 |
7 |
Is the measurement greater than 1.0 volt? | 1.0 volt | Go to Step 9 | Go to Step 8 |
8 | Repair the open circuit condition in circuit 113. Is the repair complete? | -- | -- | |
9 | Backprobe from the wiper/washer switch connector C211, terminal E to ground, using a DMM. Is the measurement greater than 1.0 volt? | 1.0 volt | Go to Step 11 | Go to Step 10 |
10 | Repair the open circuit condition in circuit 112. Is the repair complete? | -- | -- | |
11 | Replace the wiper motor module. Refer to Windshield Wiper System Module Replacement . Is the replacement complete? | -- | -- |
