Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Do the wipers park? | Go to Step 3 | Go to Step 4 | |
3 | Replace the wiper/washer switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle . Is the replacement complete? | -- | -- | |
4 | Measure the voltage from connector C211 (vehicle side), terminal E8 to ground, using a DMM. Is the measurement greater than 1.0 volt? | 1.0 volt | Go to Step 10 | Go to Step 5 |
5 | Measure the voltage from connector C211 (vehicle side), terminal E5 to ground, using a DMM. Is the measurement greater than 1.0 volt? | 1.0 volt | Go to Step 7 | Go to Step 6 |
6 | Replace the wiper motor module. Refer to Windshield Wiper System Module Replacement . Is the replacement complete? | -- | -- | |
7 |
Is the measurement greater than 1.0 volt? | 1.0 volt | Go to Step 9 | Go to Step 8 |
8 | Replace the wiper motor module. Refer to Windshield Wiper System Module Replacement . Is the replacement complete? | -- | -- | |
9 | Repair the short circuit to battery voltage condition in circuit 112. Is the repair complete? | -- | -- | |
10 |
Is the measurement greater than 1.0 volt? | 1.0 volt | Go to Step 12 | Go to Step 11 |
11 | Replace the wiper motor module. Refer to Windshield Wiper System Module Replacement . Is the replacement complete? | -- | -- | |
12 | Repair the short circuit to battery voltage condition in circuit 113. Is the repair complete? | -- | -- |
