GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 XLR 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Ignition and Start Switch Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.

  1. Disconnect the negative battery cable.
  2. Remove the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement.
  3. Remove the driver information center (DIC) switch. Refer to Driver Information Display Switch Replacement.

    4. Object Number: 1224598 Size: SH
  4. Disconnect the ignition switch electrical connector.
  5. Remove the ignition switch from the DIC pod.

    6. Carefully pull to unsnap.

Installation Procedure

    Object Number: 1224702 Size: SH
  1. Install the ignition switch into position on the DIC pod.

    2. Object Number: 1224598 Size: SH
  2. Connect the ignition switch electrical connections.

    3. Object Number: 1224702 Size: SH
  3. Install the DIC switch pod. Refer to Driver Information Display Switch Replacement.
  4. Install the driver knee bolter trim panel. Refer to Driver Knee Bolster Panel Replacement.

    5. Caution: Refer to Fastener Caution in the Preface section.

  5. Connect the negative battery cable and tighten to 15 N·m (11 lb ft).