Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
DTC Descriptor
DTC B2923: Content Theft System Inclination Sensor Signal CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ | B2923 | B2923 | -- | -- |
Inclination/Intrusion Sensor Armed Signal | B2923, B3089 | B2923, B3089 | B2923, B3089 | -- |
Inclination Sensor Alarm Signal | B2923 | B2923 | B2923 | -- |
Circuit/System Description
When the content theft deterrent (CTD) system arms and the inclination sensor is enabled, the rear integration module (RIM) receives a power-up acknowledgement from the inclination sensor via the inclination sensor signal circuit.
Conditions for Running the DTC
| • | The inclination sensor is enabled |
| • | The CTD system has armed |
Conditions for Setting the DTC
The RIM does not receive the power-up acknowledgement from the inclination sensor
Action Taken When the DTC Sets
The RIM will ignore all inputs from the inclination sensor for the remainder of the CTD system arming cycle
Conditions for Clearing the DTC
A current DTC will clear when the RIM receives a power-up acknowledgement from the inclination sensor during the next CTD system arming cycle
Reference Information
Schematic Reference
Theft Deterrent System Schematics
Connector End View Reference
Description and Operation
Content Theft Deterrent (CTD) Description and Operation
Electrical Information Reference
| • | Circuit Testing |
| • | Wiring Repairs |
Scan Tool Reference
Refer to Control Module References for scan tool information
Circuit/System Verification
- Ignition OFF, disconnect the X2 harness connector at the RIM. Disconnect the harness connector at the inclination sensor.
- Verify a test lamp does not illuminate between the signal circuit terminal 3 at the inclination sensor and B+.
- Test for less than 2 ohms between the signal circuit terminal 3 at the inclination sensor and the signal circuit terminal 10 at the RIM X2 harness connector.
- Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal 3 at the inclination sensor and ground.
- If all circuits test normal, test or replace the inclination sensor.
| ⇒ | If the test lamp illuminates, test the signal circuit for a short to ground. |
| ⇒ | If greater than the specified range, test the signal circuit for an open/high resistance. |
| ⇒ | If the test lamp illuminates, test the signal circuit for a short to B+. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure
