Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

The actual throttle position and airflow rate is compared to an expected throttle position and airflow rate based on engine load. The engine control module (ECM) determines engine load based on inputs from the mass air flow (MAF) sensor and the manifold absolute pressure (MAP) sensor. Further comparisons are done to distinguish if a sensor is at fault, and the respective DTC will set.

The ECM uses the following information to calculate an expected airflow rate:

P0068

P0121

The ECM detects that the airflow rate is more than the calculated airflow for more than 0.2 second.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

1. If DTCs P0101, P0106, P0120, P0220, and P1182 are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
2. Ignition ON, observe the scan tool BARO, MAP, and the SC Inlet Pressure sensor parameters. The readings should be within the range specified for your altitude. Determine the altitude at your current location and refer to Altitude Versus Barometric Pressure .

Important: You must perform the Circuit/System Verification before proceeding with the Circuit/System Testing.

1. Start the engine. The Manifold Absolute Pressure (MAP) and SC Inlet Pressure Sensor parameters should decrease and closely match each other.

⇒	If the MAP sensor parameter does not decrease, refer to DTC P0106 .

⇒	If the SC Inlet Pressure sensor parameter does not decrease, refer to DTC P1182 .

2. Engine running, inspect for any of the following conditions:

•	Vacuum hoses for splits, leaks, and proper connections

•	Air leaks at throttle body mounting area and intake manifold sealing surfaces

•	A supercharger bypass valve that is binding or incorrectly adjusted

⇒	If any of the above conditions are found, repair as necessary.

3. While taking a snapshot of the engine data list, perform the following actions. Idle the engine. Increase the engine speed slowly to 3,000 RPM, then return to an idle. Observe the Mass Air flow (MAF) Sensor parameter frame by frame with a scan tool. The MAF sensor parameter should change smoothly as the engine speed is increased and is returned to idle.

⇒	If the MAF sensor parameter does not change smoothly as the engine speed is increased and is returned to idle, refer to DTC P0101 .

4. Engine running, slowly depress the accelerator pedal to a WOT position, then slowly release the pedal while comparing the TP Sensor 1 and TP Sensor 2 parameters. The difference between the parameters should be less than 4 percent.

⇒	If the voltage is 4.8-5.2 volts, then proceed to the next numbered step.

⇒	If TP Sensor 1 and TP Sensor 2 parameters differ more than 4 percent, refer to DTC P0120, P0122, P0123, P0220, P0222, P0223, or P2135 .

Caution: Turn OFF the ignition before inserting fingers into the throttle bore. Unexpected movement of the throttle blade could cause personal injury.

5. Ignition OFF, inspect the throttle body for the following conditions:

•	Loose or damaged throttle blade

•	Broken throttle shaft

•	Any throttle body damage

⇒	If any of these conditions exist, replace the throttle body assembly.

Always perform the Diagnostic Repair Verification after completing the diagnostic procedure.