GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2008 🢒 SRX 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Rear Seat Number 2 Back Pivot Actuator Motor Replacement - Cushion

Removal Procedure
  1. Remove the seat cushion frame. Refer to Rear Seat Number 2 Cushion Frame Replacement .

    2. Object Number: 1261000 Size: SH
  2. Disconnect the drive cables from the horizontal motor (1).
  3. Disconnect the electrical connector from the motor.
  4. Remove the motor.

Installation Procedure

    Object Number: 1261000 Size: SH
  1. Install the horizontal seat motor (1) to the frame.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the horizontal seat motor screws.

    3. Tighten
    Tighten the screws to 10 N·m (88 lb in).

  3. Install the cables into the motor.
  4. Connect the electrical connector to the seat motor.
  5. Install the seat cushion frame. Refer to Rear Seat Number 2 Cushion Frame Replacement .
  6. Calibrate the seat. Refer to Power Folding Seat Calibration .