GM Service Manual Online
For 1990-2009 cars only

Circuit Description

When the electronic brake control module (EBCM) is replaced, software and calibrations are flash programmed into the EBCM. The EBCM receives the vehicle identification number information from the vehicle in order for the EBCM to automatically calibrate to the vehicle.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC C0565 Vehicle Identification Number (VIN) Information Error

Conditions for Running the DTC

    • The ignition is ON.
    • Ignition voltage is greater than 8 volts.

Conditions for Setting the DTC

One or more of the following conditions are present:

    • The incorrect EBCM is installed on the vehicle.
    • The incorrect software or calibrations have been flash programmed into the EBCM.

Action Taken When the DTC Sets

If equipped, the following actions occur:

    • The EDC/TCS are disabled.
    • The TCS indicator turns ON.

The DIC displays the Service Traction System message.

Conditions for Clearing the DTC

    • The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
    • The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids

If the DTC was set after EBCM replacement, verify that the replacement EBCM and software are correct for the vehicle.

Step

Action

Yes

No

Schematic Reference: Antilock Brake System Schematics

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

Is the electronic brake control module (EBCM) the correct module for the vehicle?

Go to Step 4

Go to Step 3

3

Replace the EBCM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 5

Go to Step 4

4

Reprogram the EBCM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 5

--

5

  1. Use the scan tool in order to clear the DTCs.
  2. Turn ON the ignition.

Does the DTC reset?

Go to Step 2

System OK