The theft deterrent control module sends the fuel continue password to the engine control module (ECM) via the serial data circuit. The ECM verifies the fuel continue password received matches the password stored in memory. If the fuel continue password is correct, the ECM enables the starting and fuel delivery systems. When replacing a ECM with a GM SPO replacement part, the new ECM will learn the incoming fuel continue password immediately upon receipt. DTC P1630 is an informational code indicating the ECM is ready to learn the fuel continue password.
This diagnostic procedure supports the following DTC:
DTC P1630 Theft Deterrent Learn Mode Active
The ignition is ON.
The ECM remains in theft deterrent password learn mode for more than 2 seconds.
• | The ECM sends a serial data message to the theft deterrent control module to illuminate the SECURITY indicator. |
• | The ECM will not illuminate the malfunction indicator lamp (MIL). |
• | A history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction. |
• | The DTC can be cleared by using a scan tool. |
A GM SPO replacement ECM is in a functional state to learn the password from the theft deterrent control module. If the theft deterrent control module is replaced, the ECM must be placed in password learning mode to relearn the new password. Once learned, the password becomes permanent information that remains in the ECM. The loss of ECM battery or ignition voltage does not affect the programmed password information. Refer to Programming Theft Deterrent System Components .
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |