Removal Procedure
- Remove the garnish moldings. Refer to Body Side Rear Upper Garnish Molding Replacement in Interior Trim.
- Lower the rear of the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
- Disconnect the digital radio antenna connectors (1).
- Remove the antenna bolt (2) and expansion sleeve (3).
- Squeeze the retainer (4), located on the shaft of the antenna near the base, with a pair of pliers.
- Remove the digital radio antenna.
Notice: DO NOT apply paint or clear coat to the antenna. This will damage the function of the antenna, causing poor reception or loss of signal reception.
Notice: Use care when removing and installing the headliner. If reusing the headliner lay the headliner down flat on a clean surface. Excessive bending will damage the headliner.
Important: The retainer, located on the shaft of the radio antenna, was designed for assembly plant operations to retain the digital antenna to the roof before the bolt is installed. If the retainer on the radio antenna is broken or damaged during service of the antenna, the antenna will still operate as designed and should be reused.
Installation Procedure
- Install the digital radio antenna to the roof.
- Route the wiring pigtail to the side in the slot on the antenna shaft and install the antenna expansion sleeve (3) and bolt (2) to the antenna shaft.
- Connect the antenna connectors (1).
- Install the antenna cable connection above the AM/FM antenna module.
- Install the antenna cable hold down clips.
- Align the headliner to the roof panel.
- Install the rear garnish moldings. Refer to Body Side Rear Upper Garnish Molding Replacement in Interior Trim.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolt to 6 N·m (53 lb in).
