Schematic Reference: Exterior Lights Schematics

Connector End View Reference: Master Electrical Component List in Wiring Systems

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Turn ON the ignition, with the engine OFF.
2. Depress and hold the brake pedal.
3. Move the gear selector through the gear ranges.
4. Observe the backup lamps.
5. Place the gear selector in the PARK position.
6. Release the brake pedal.

Did the backup lamps operate properly?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With the scan tool, command the Reverse Lamp Relay ON and OFF from the rear integration module (RIM) Output Control data list.

Does the reverse relay turn ON and OFF with each command?

Go to Step 4

Go to Step 5

1. Turn OFF the ignition.
2. Disconnect the reverse relay. Refer to Relay Replacement in Wiring Systems.
3. Turn ON the ignition, with the engine OFF.

Do the backup lamps turn OFF?

Go to Step 5

Go to Step 7

1. Turn OFF the ignition.
2. Connect a test lamp between the reverse relay control side supply voltage circuit and the reverse lamp relay control circuit.
3. Turn ON the ignition, with the engine OFF.
4. With a scan tool, command the Reverse Lamp Relay ON and OFF.

Does the test lamp turn ON and OFF with each command?

Go to Step 8

Go to Step 6

Test the reverse lamp relay control circuit for a short ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 9

Test the backup lamp supply voltage circuit for a short to battery positive voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 8

Inspect for poor connections at the reverse lamp relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 10

Inspect for poor connections at the harness connector of the RIM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 11

Replace the reverse relay. Refer to Relay Replacement in Wiring Systems.

Did you complete the replacement?

Go to Step 12

--

Replace the RIM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming.

Did you complete the replacement?

Go to Step 12

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2