Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

1

Head Restraint Guides

Tip

1. Locate the 2 holes on the top of the seat back foam.
2. Using a sharp cutting tool, cut a 20 mm (¾ in) wide X in the center of the depressions. The center of the X must be exactly 45 mm (1 ¾ in) from the center of the front seam.
3. Fully install the left side guide pin. The small indicator hole on the pin should be facing inboard.
4. Fully install the right side guide pin. The button should be facing outboard.

2

Rear Seat Head Restraint