Caution: The high intensity discharge system produces high voltage and current. In order to reduce the risk of severe shocks and burns, the battery negative cable must be disconnected any time service work is being performed on or around the high intensity discharge system.

Caution: The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove either the left front or right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
3. Remove either the left front or right front fascia extension. Refer to Front Bumper Fascia Extension Replacement.

1

Front Turn Signal and Fog Lamp Assembly Screw (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Procedure

Disconnect the forward lamp harness electrical connector from the lamp assembly electrical connector.

Tighten
2 N·m (18 lb in).

2

Front Turn Signal and Fog Lamp Assembly Hinge

Procedure

Rotate the inboard side of the lamp assembly outward in order to release the two hinge points from the park and turn signal lamp bracket.

3

Front Turn Signal and Fog Lamp Assembly