Schematic Reference: Data Link Connector Schematics

Connector End View Reference: Master Electrical Component List

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Observe the following parameters in each of the door modules and rear integration module (RIM) data list:

•	Driver Door Jamb Sw.

•	Pass. Door Jamb Sw.

•	Left Rear Door Jamb Sw.

•	Right Rear Door Jamb Sw.

2. Open and close each door while observing the respective parameter.

Does the scan tool display change from On to Off?

Go to Step 3

Go to Symptoms - Lighting Systems

1. Install a scan tool. Select diagnostic circuit check and then class 2 power mode.
2. Close all the doors.
3. Turn ON the ignition, with the engine OFF.
4. Wait 5 seconds then turn the ignition OFF.
5. Wait the time-out for the retained accessory power (RAP).

Did the scan tool display the RAP power mode, then time-out and display Off-Awake power mode?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 4

Inspect for poor connections at the harness connector of the dash integration module (DIM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 6

Go to Step 5

Replace the DIM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the procedure?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2