Schematic Reference: Symptoms - Wiper/Washer Systems

Connector End View Reference: Wiper/Washer Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Turn ON the ignition.
2. Turn the windshield wiper/washer switch OFF.

Are the windshield wipers always ON?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

Remove the WPR SW 10A fuse.

Are the windshield wipers always ON?

Go to Step 4

Go to Step 7

1. Disconnect the windshield wiper motor connector.
2. Test the windshield wiper switch signal 1 circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 5

Test the windshield wiper switch signal 2 circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 6

Test the windshield wiper motor high speed circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 9

Inspect for poor connections at the windshield wiper/washer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 8

Replace the windshield wiper/washer switch. Refer to Windshield Wiper and Washer Switch Replacement .

Is the repair complete?

Go to Step 11

--

Inspect for poor connections at the windshield wiper motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 10

Replace the windshield wiper motor cover. Refer to Windshield Wiper Motor Cover Replacement - Front .

Is the repair complete?

Go to Step 11

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3