Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics

Connector End View Reference: Master Electrical Component List in Wiring Systems

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Turn ON the ignition, with the engine OFF.
2. Turn the flash to pass switch ON and OFF.

Did the flash to pass function operate properly?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Do the high beam headlamps operate properly?

Go to Step 4

Go to Headlamps Inoperative - High Beams

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With a scan tool, observe the Flash to Pass Switch parameter in the dash integration module (DIM) Inputs data list.
4. Turn the flash to pass switch ON and OFF several times.

Does the Flash to Pass Switch parameter turn ON and OFF with the switch?

Go to Step 5

Go to Step 6

With a scan tool, command the High Beam Flash to Pass ON and OFF from the DIM Special Functions, Output Control data list.

Do the high beam headlamps turn ON and OFF with each command?

Go to Step 10

Go to Step 7

1. Turn OFF the ignition.
2. Disconnect the multifunction, turn signal switch.
3. Connect a 3-amp fused jumper wire between the flash to pass switch signal circuit of the multifunction, turn signal switch and the ground circuit of the multifunction, turn signal switch.
4. Turn ON the ignition, with the engine OFF.
5. With a scan tool, observe the Flash to Pass Switch parameter in the DIM Inputs Data List.

Does the scan tool indicate that the Flash to Pass Switch parameter is ON?

Go to Step 9

Go to Step 8

Test for an open or high resistance in the headlamp high beam relay control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 10

Test for an open or high resistance in the flash to pass switch signal circuit of the headlamp dimmer switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 10

Inspect for poor connections at the harness connector of the multifunction, turn signal switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 11

Inspect for poor connections at the harness connector of the DIM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 12

Replace the multifunction, turn signal switch. Refer to Turn Signal Multifunction Switch Replacement in Steering Wheel and Column.

Did you complete the replacement?

Go to Step 13

--

Important: Perform the setup procedure for the DIM.

Replace the DIM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 13

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2