Automatic Transmission Electrical Connector Passage Sleeve Replacement. Cadillac SLS 2008

For 1990-2009 cars only

Makes 🢒 Cadillac 🢒 2008 🢒 SLS 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 6L50/6L80/6L90 🢒 Automatic Transmission Electrical Connector Passage Sleeve Replacement

Callout

Component Name

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the transmission fluid pan. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
Disconnect the vehicle wire harness electrical connector from the transmission electrical Connector Sleeve. Refer to Automatic Transmission Inline 16-Way Connector Description .

Electrical Connector Slide Lock

Tip
Pull down on the slide lock to remove the sleeve. Push up on the slide lock after sleeve installation.

Electrical Connector Sleeve

Tip

•	Use the DT 47715 Electrical Connector Passage Sleeve Remover/Installer and J 42183 Driver Handle to remove and install the electrical connector sleeve.

•	The distance (a) from the case surface to the end of the sleeve should be 14-16 mm.

O-Ring Seal (Qty: 2)

Tip
Use a NEW O-ring seal.

Lip Seal

Tip
Use a NEW lip seal.