Tools Required

J 45756 Output Shaft Seal Installer

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
3. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement in Propeller Shaft.
4. Remove the rear output shaft seal by prying it out with a flat tipped screwdriver.

1. Using J 45756 , install a NEW front output shaft seal.
2. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement in Propeller Shaft.
3. Check the fluid level. Add fluid, if necessary.
4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
5. Lower the vehicle.