Side Object Sensor Module Scan Tool Information Left Side
| Table 1: | Left Side Object Detection Scan Tool Parameters |
| Table 2: | Left Side Object Detection Module Output Controls |
Parameter | System State | Expected Value | Definition |
|---|---|---|---|
Operating Conditions: Ignition ON | |||
Beam 1-7 Range | -- | cm | The scan tool displays the range in centimeters. |
Driver Interface 1-16 History | -- | Enabled | The scan tool displays Enabled, Disabled, Turn Signal, Clean Required, Service Required and Unavailable. This captures any interactions with the sensors. |
Left SOD Sensor Status | -- | Low Power | The scan tool displays Low Power, OFF, Disabled Reporting, Not Reporting and Blocked. This is the status of the left side object detection sensor. |
Obj Present in Alert Zone | -- | No | The scan tool displays Yes or No. Yes is displayed if an object is detected in the specified alert zone. |
Object in Beam 1-7 Present | -- | No | The scan tool displays Yes or No. Yes is displayed when an object is detected in the specified beam area. |
Scan Tool Output Control | Description |
|---|---|
Force Static Alert Zone | This output control calibrates the left side object detection sensor |
Side Object Sensor Module Scan Tool Information Right Side
| Table 1: | Right Side Object Detection Scan Tool Parameters |
| Table 2: | Right Side Object Detection Module Output Controls |
Parameter | System State | Expected Value | Definition |
|---|---|---|---|
Operating Conditions: Ignition ON | |||
Beam 1-7 Range | -- | cm | The scan tool displays the range in centimeters. |
Driver Interface 1-16 History | -- | Enabled | The scan tool displays Enabled, Disabled, Turn Signal, Clean Required, Service Required and Unavailable. This captures any interactions with the sensors. |
Right SOD Sensor Status | -- | Low Power | The scan tool displays Low Power, OFF, Disabled Reporting, Not Reporting and Blocked. This is the status of the right side object detection sensor. |
Obj Present in Alert Zone | -- | No | The scan tool displays Yes or No. Yes is displayed if an object is detected in the specified alert zone. |
Object in Beam 1-7 Present | -- | No | The scan tool displays Yes or No. Yes is displayed when an object is detected in the specified beam area. |
Scan Tool Output Control | Description |
|---|---|
Force Static Alert Zone | This output control calibrates the right side object detection sensor |
