GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2006 🢒 DTS 🢒 Body 🢒 Wiring Systems 🢒 Transmission Control Replacement

Removal Procedure

    Important: Incase of power loss the brake transmission shift interlock (BTSI) switch must be manually released in order to remove the console trim plate. If no power loss proceed to step 4.

  1. Lift up the console trip plate. Refer to Front Floor Console Trim Plate Replacement .

    2. Important: Wear gloves to protect hands from sharp edges.


    Object Number: 1709099 Size: SH
  2. Remove the BTSI pin cover (1).

    3. Object Number: 1709101 Size: SH
  3. Depress BTSI switch pin (1) to release the shifter out of park.

    4. Object Number: 105570 Size: SH
  4. Remove the console trim plate (1). Refer to Front Floor Console Trim Plate Replacement .

    5. Object Number: 291754 Size: SH
  5. Unsnap the shift cable terminal from the shifter pin.
  6. Disconnect the automatic transmission shift lock actuator solenoid wire harness connector.

    7. Object Number: 291888 Size: SH
  7. Remove the shifter fasteners.
  8. Remove the shifter assembly.

Installation Procedure

    Object Number: 291888 Size: SH
  1. Install the shifter assembly.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the shifter fasteners.

    3. Tighten
    Tighten the shifter fasteners to 9 N·m (79 lb in).


    Object Number: 291754 Size: SH
  3. Insert the shift cable onto the shifter control.
  4. Connect the automatic transmission shift lock solenoid wire harness connector.
  5. Adjust the shift cable as follows:
    6. 5.1. Place the shifter into the N (neutral) position.
    5.2. Loosen the shifter adjuster nut.
    5.3. Tighten the adjuster nut.

    Tighten
    Tighten the adjuster nut to 25 N·m (18 lb ft).


    Object Number: 105570 Size: SH
  6. Install the console trim plate (1). Refer to Front Floor Console Trim Plate Replacement .