Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0775: Low Tire Pressure System Sensors Not LearnedCircuit/System Description
The remote control door lock receiver (RCDLR) receives a radio frequency (RF) transmission from each tire pressure sensor. Each sensors RF transmission contains its own unique identification (ID) code that must be learned into the RCDLR memory. Once all 4 IDs have been learned and vehicle speed is 25 mph or greater, the RCDLR continuously compares IDs in received transmission to its learned IDs to determine if all 4 sensors are present.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The RCDLR has not undergone the tire pressure sensor learn procedure.
Action Taken When the DTC Sets
The driver information center (DIC) displays the SERVICE TIRE MONITOR warning message.
Conditions for Clearing the DTC
A current DTC will clear when the RCDLR has undergone the sensor learn procedure.
Diagnostic Aids
A newly replaced RCDLR will set DTC C0775 on its initial ignition ON cycle. Tire pressure sensor learn procedure must be performed.
Reference Information
Schematic Reference
Tire Pressure Monitoring System Schematics
Description and Operation
Tire Pressure Monitor Description and Operation
Electrical Information Reference
Scan Tool Reference
Special Tools Required
Tire pressure monitor diagnostic tool J-46079
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for IPC or RCDLR replacement, setup, and programming |
