Preliminary Procedure

1. Remove the front seat. Refer to Front Seat Replacement - Bucket.
2. Remove the front seat back cushion cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement.
3. Remove the inflatable restraint side impact module. Refer to Driver or Passenger Seat Side Inflatable Restraint Module Replacement.

1

Front Seat Lumbar Subsystem Bolt (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
9 N·m (80 lb in)

2

Front Seat Lumbar Subsystem

Procedure

1. Disconnect the electrical connector.
2. Note the routing of the electrical harness for installation.

Preliminary Procedure

Remove the front seat back cushion cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement.

1

Front Seat Lumbar Sub System Rivet (Qty: 2)

Caution: Use the proper eye protection when drilling to prevent metal chips from causing physical injury.

Procedure

Drill out both guide rivets before removing.

2

Front Seat Lumbar Sub System

Procedure

1. Disconnect the electrical connector.
2. Note the routing of the electrical harness for installation.
3. Transfer components as necessary.
4. The new lumbar wires would have to be inserted into the guides and then the guides re-riveted at the bottom.