- Loosen the jam nut (1) on the outer tie rod.
Notice: Care must be taken that the boots are not twisted when rotating the
inner tie rods, or damage to the boots may result.
- Rotate the inner tie rod to the required toe specification setting. Refer to
Wheel Alignment Specifications .
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the jam nut to the outer tie rod.
Tighten
Tighten the nut to 75 N·m (55 lb ft).
- Check the toe setting after tightening. Refer to
Wheel Alignment Specifications .
- Re-adjust the toe setting if necessary.