For 1990-2009 cars only
- Cycle the sunroof window from full open to closed position.
- Loosen the adjusting screws on both windows.
- Adjust both sunroof windows to a uniform seal tension fore/aft and panel to panel.
- Adjust the corners of the front window panel using the following guidelines:
- Tighten the sunroof window adjustment screws.
- Cycle sunroof window to vent, then close. Cycle the sunroof window from full open to closed position.
- Using 0.25 mm (0.01 in) shim or a similar item to check the sunroof window seal for even compression around the seal opening periphery and between the window panels.
- Inspect the sunroof window adjustment. Adjust if necessary.
Important: Correct adjustment cannot be achieved if the sunroof window is closed from vent position.
Important: Do Not remove or lower headliner to access sunroof window screws.
To ensure proper adjustment on the sunroof windows all eight (8) screws Must be loosen.| • | Adjust the front of the front sunroof window to 0.0 mm - 1.5 mm (0.0 in - 0.06 in ) below the top surface of the roof panel. |
| • | Adjust the rear of the rear sunroof window to 0.0 mm + 1.5 mm (0 .0 in + 0.06 in ) above the top surface of the roof panel. |
| • | Adjust the rear edge of the front sunroof window to leading edge of the rear window to 0.0 mm +1.0 mm (0.0 in + .04in) to the panel shingling. |
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the sunroof window adjusting screws to 4 N·m
(35 lb in).
