Engine Mount Replacement - Right Side w/AWD

1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection.
2. Remove the cross vehicle brace. Refer to Cross Vehicle Brace Replacement.
3. Remove the exhaust system. Refer to Exhaust System Replacement.
4. Remove the upper engine mount retaining nut (1).



5. Remove the lower engine mount retaining nuts.
6. Install a screw jack with a block of wood under the oil pan for support.

Important: Note position of the engine mount prior to removing mount.

7. Using the screw jack, raise the engine enough to remove the engine mount.
8. Remove the engine mount from the vehicle.

Important: Ensure the engine mount is positioned correctly.

1. Install the engine mount to the vehicle.
2. Using the screw jack, lower the engine.
3. Remove the screw jack and block of wood supporting the engine.

Notice: Refer to Fastener Notice in the Preface section.




4. Install the upper engine mount retaining nut (1).

Tighten
Tighten the nut to 80 N·m (59 lb ft).

5. Install the right and left lower engine mount retaining nuts.

Tighten
Tighten the nut to 80 N·m (59 lb ft).

6. Install the exhaust system. Refer to Exhaust System Replacement.
7. Install the cross vehicle brace. Refer to Cross Vehicle Brace Replacement.
8. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection.

Engine Mount Replacement - Right Side w/RWD

1. Remove the tower brace. Refer to Cross Vehicle Brace Replacement.
2. Remove the nut (1) from the top of the engine mount.
3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
4. Position a screw jack and a block of wood under the engine oil pan.



5. Remove the right and left engine mount lower nut (1).



6. Using the screw jack, raise the engine enough to remove the engine mount (1).



7. Be sure to remove the engine mount slotted washer (1) or plastisol insert washer (2) between the engine mount and the frame.

1. Install the engine mount to the vehicle.

Ensure the slotted washer (1) or plastisol insert washer (2) is properly installed and located between the engine mount and the frame.

2. Lower the engine onto the engine mount.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the right and left engine mount lower nut (1).

Tighten
Tighten the nut to 80 N·m (59 lb ft).




4. Remove the screw jack and a block of wood from under the engine oil pan.
5. Lower the vehicle.
6. Install the nut (1) to the top of the engine mount.

Tighten
Tighten the nut to 80 N·m (59 lb ft).

7. Install the tower brace. Refer to Cross Vehicle Brace Replacement.

Engine Mount Replacement - Right Side Second Design RWD