Discharge Hose Replacement LS2

Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
2. Remove the air deflector. Refer to Front Air Deflector Replacement.
3. Remove the radiator. Refer to Radiator Replacement.



4. Remove the bolt that holds the compressor discharge hose to the compressor.
5. Separate the compressor discharge hose from the compressor.
6. Remove the discharge hose clamp bolt.



7. Remove the bolt (1) from the condenser.
8. Separate the discharge line from the condenser.
9. Remove the discharge hose.
10. Remove and discard the O-ring seals.

1. Lubricate the O-rings. Refer to O-Ring Replacement .
2. Install the discharge hose.
3. Connect the discharge hose to compressor.

Notice: Refer to Fastener Notice in the Preface section.




4. Install the discharge hose bolt.

Tighten
Tighten the bolt to 9.8 N·m (87 lb in).

5. Install the discharge hose clamp bolt.
6. Install the discharge hose to the condenser.



7. Install the bolt (1) to the discharge hose.

Tighten
Tighten the bolt to 5.4 N·m (48 lb in).

8. Install the radiator. Refer to Radiator Replacement.
9. Install the air deflector. Refer to Front Air Deflector Replacement.
10. Evacuate and recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging .
11. Leak test the fittings of the component using J 39400-A .

Discharge Hose Replacement LY7

Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
2. Remove the front bumper facia deflector. Refer to Front Bumper Fascia Air Deflector Replacement .



3. Remove the bolt that holds the compressor discharge hose to the compressor.
4. Separate the compressor discharge hose from the compressor.



5. Remove the bolt (1) from the condenser.
6. Separate the discharge line from the condenser.
7. Remove the discharge hose.
8. Remove and discard the O-ring seals.

1. Lubricate the O-rings. Refer to O-Ring Replacement .
2. Install the discharge hose.
3. Connect the discharge hose to compressor.

Notice: Refer to Fastener Notice in the Preface section.




4. Install the discharge hose bolt.

Tighten
Tighten the bolt to 9.8 N·m (87 lb in).

5. Install the discharge hose to the condenser.



6. Install the bolt (1) to the discharge hose.

Tighten
Tighten the bolt to 5.4 N·m (48 lb in).

7. Install the front bumper facia deflector. Refer to Front Bumper Fascia Air Deflector Replacement .
8. Evacuate and recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging .
9. Leak test the fittings of the component using J 39400-A .