GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2007 🢒 CTS 🢒 Body Hardware and Trim 🢒 Interior Trim and Paneling 🢒 Rear Bumper Fascia Replacement

Removal Procedure
  1. Remove the rear fascia extension. Refer to Rear Bumper Fascia Extension Replacement .

    2. Object Number: 707962 Size: SH
  2. Remove the push-in retainers (2) by cutting with diagonal cutters.

    3. Object Number: 707965 Size: SH
  3. Open the rear compartment.
  4. Remove the rear sill plate. Refer to Rear Compartment Sill Trim Plate Replacement .
  5. Remove the nuts (1) securing the fascia (2) to the rear end panel.
  6. Remove the bolts (3) securing the fascia to the horizontal joint at the quarter panel (4).
  7. Remove the fascia by sliding rearward to disengage the fascia from the rear bumper brackets.

Installation Procedure

    Object Number: 707965 Size: SH
  1. Position the fascia (2) to the body.
  2. Align the studs on the fascia to the holes in the rear end panel.
  3. Install the fascia to the quarter panel pressing into place until fully secured.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the nuts (1) to secure the fascia to the rear end panel.

    5. Tighten
    Tighten the nuts (1) to 6 N·m (53 lb in).

  5. Position the fascia to the horizontal joint at the quarter panel (4).
  6. Install the bolts (3) in order to secure the fascia to the quarter panel (4).

    7. Tighten
    Tighten the bolts to 3 N·m(27 lb in).


    Object Number: 707962 Size: SH
  7. Install new push-in retainers (2) to secure the fascia to the floorpan.
  8. Install the sill plate. Refer to Rear Compartment Sill Trim Plate Replacement .
  9. Install the rear fascia extension. Refer to Rear Bumper Fascia Extension Replacement .
  10. Close the rear compartment.