Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
.
- Remove the steering wheel inflatable restraint module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
.
- Disconnect the electrical connectors for the steering wheel control switch.
- Remove the retaining screws from the steering wheel control switch.
- Remove the retainer and screw from the steering wheel control harness.
- Carefully pull the control switch assembly away from the steering wheel.
- Remove the control switch assembly from the steering wheel.
- Remove the wire harness from the control switch assembly.
Installation Procedure
- Install the wire harness to the steering wheel control switch assembly.
- Align the control switch assembly engagement tabs to the steering wheel.
Push in on the control switch assembly in order to secure the assembly to the steering wheel.
Notice: Refer to Fastener Notice in the Preface section.
- Install the control harness retainer and screw.
Tighten
Tighten the screw to 2.3 N·m (20 lb in).
- Install the control switch assembly screws
Tighten
Tighten the screws to 2.3 N·m (20 lb in).
- Connect the electrical connector to the steering wheel control.
- Secure the connector to the retaining clip.
- Install the inflatable restraint module. Refer to
Inflatable Restraint Steering Wheel Module Replacement
.
- Enable the SIR. Refer to
SIR Disabling and Enabling
.