GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value

Yes

No

Schematic Reference: Radio/Audio System Schematics

Connector Reference: Entertainment Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Turn ON the ignition, with the engine ON.
  2. With the scan tool perform the microphone test under amplifier special functions menu.

Did the test pass?

--

Go to Step 9

Go to Step 3

3

  1. Turn ON the ignition, with the engine OFF.
  2. Disconnect the noise compensation microphone.
  3. Measure the voltage from the noise compensation microphone supply voltage circuit to the drain wire.

Does the voltage measure near the specified value?

8 V

Go to Step 4

Go to Step 5

4

Replace the noise compensation microphone. Refer to Radio Volume Compensator Interior Noise Microphone Replacement .

Did you complete the replacement?

--

Go to Step 9

--

5

Test the noise compensation microphone supply voltage circuit for an open or short. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 9

Go to Step 6

6

Test the drain wire circuit for an open or short. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 9

Go to Step 7

7

Inspect for poor connections at the amplifier. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 9

Go to Step 8

8

Replace the amplifier. Refer to Radio Speaker Amplifier Replacement in Entertainment.

Did you complete the repair?

--

Go to Step 9

--

9

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 3