Notice:
• Turn the ignition OFF when installing or removing the control module connectors and disconnecting or reconnecting the power to the control module (battery cable, powertrain control module (PCM)/engine control module (ECM)/transaxle control module
(TCM) pigtail, control module fuse, jumper cables, etc.) in order to prevent internal control module damage. • Control module damage may result when the metal case contacts battery voltage. DO NOT contact the control module metal case with battery voltage when servicing a control module, using battery booster cables, or when charging the vehicle battery. • In order to prevent any possible electrostatic discharge damage to the control module, do no touch the connector pins or the soldered components on the circuit board. • Remove any debris from around the control module connector surfaces before servicing the control module. Inspect the control module connector gaskets when diagnosing or replacing the control module. Ensure that the gaskets are installed correctly.
The gaskets prevent contaminant intrusion into the control module. • The replacement control module must be programmed.
Important: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100 percent. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5000 km (3,000 mi) from the last engine oil change.
Important: It is necessary to record the remaining automatic transmission fluid life. If the replacement module is not programed with the remaining automatic transmission fluid life, the automatic transmission fluid life will default to 100 percent. If the replacement module is not programmed with the remaining automatic transmission fluid life, the automatic transmission fluid will need to be changed at 83000 km (50,000 mi) from the last automatic transmission fluid change.
Removal Procedure
- Using a scan tool, retrieve the percentage of remaining engine oil and the remaining automatic transmission fluid life. Record the remaining engine oil and the remaining automatic transmission fluid life.
- Turn OFF the ignition.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the front air deflector. Refer to Front Air Deflector Replacement .
- Remove the bolt (1) from the powertrain control module (PCM) housing cover.
- Push the cover outboard to release the locking tab.
- Swing the cover open and remove the cover from the vehicle.
- Remove the PCM from the housing.
- Loosen the screws (1) at the PCM electrical connectors.
- Disconnect the PCM electrical connectors.
- Remove the PCM from the vehicle.
Installation Procedure
- Install the PCM to the vehicle.
- Install the PCM wiring harness.
- Tighten the PCM electrical connector screws (1).
- Install the PCM to the PCM housing.
- Install the PCM housing cover.
- Install the bolt (1) to the PCM cover housing.
- Install the front air deflector. Refer to Front Air Deflector Replacement .
- Lower the vehicle.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Program the PCM. Refer to Engine Control Module Programming and Setup .
- Refer to Control Module References for programming and setup information.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the PCM electrical connector bolts to 8 N·m (71 lb in).
Tighten
Tighten the PCM housing cover bolt to 10 N·m (89 lb in).
