Circuit Description
The brake pedal position sensor is a potentiometer. The electronic brake control module (EBCM) supplies a 5-volt reference circuit and low reference circuit to the brake pedal position sensor. The brake pedal position sensor signal circuit is a direct input to the EBCM. The EBCM determines the brake pedal position based on the voltage from the brake pedal position sensor. The EBCM converts the brake pedal position sensor feed back voltage to a digital signal and puts it on the class 2 communication bus. If the voltage is less than 0.25 volts, then DTC C0283 will set.
Conditions for Running the DTC
| • | The EBCM control module must be powered. |
| • | This test is run continuously. |
Conditions for Setting the DTC
The brake pedal position sensor voltage is less than 0.25 volts for a consecutive period of 610 milliseconds.
Action Taken When the DTC Sets
When DTC C0283 is set the following will occur:
| • | The engine drive control is disabled. |
| • | The panic brake assist is disabled. |
| • | The traction control system is disabled. |
| • | The vehicle stability enhancement system is disabled. |
| • | The service vehicle soon lamp will illuminate. |
Conditions for Clearing the DTC
| • | The current DTC will clear when the fault is no longer present. |
| • | A history DTC clears after 100 consecutive ignition cycles in which no faults have occurred. |
| • | Clear the DTC with a scan tool. |
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: Interior Lights Schematics and Antilock Brake System Schematics in Antilock Brake System Connector End View Reference: Master Electrical Component List in Wiring Systems | ||||
1 | Did you perform the Diagnostic System Check - Lighting Systems? | -- | Go to Step 2 | |
2 |
Is the BPP Sensor A/D Conversi parameter within the specified range? | 0.25-4.90 V | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Is the BPP Sensor A/D Conversi parameter less than the specified value? | 0.25 V | Go to Step 4 | Go to Step 6 |
4 | Test the 5-volt reference circuit of the BPP sensor for a short to ground or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 5 |
5 | Test the signal circuit of the BPP sensor for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 7 |
6 | Inspect for poor connections at the harness connector of the BPP sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 8 |
7 | Inspect for poor connections at the harness connector of the electronic brake control module (EBCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 9 |
8 |
Important: Always perform the calibration procedure for the BPP sensor. Refer to Brake Pedal Position Sensor Calibration Description and Operation . Replace the BPP sensor. Refer to Brake Pedal Position Sensor Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
9 |
Did you complete the replacement? | -- | Go to Step 10 | -- |
10 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
