SMU - SECTION 3F - REVISED STEERING WHEEL REMOVAL. Buick Skylark 1996

SUBJECT: SERVICE MANUAL UPDATE - SECTION 3F - REVISED STEERING WHEEL REMOVAL PROCEDURE

MODELS: 1996 BUICK SKYLARK 1995-96 CHEVROLET CAVALIER 1996 OLDSMOBILE ACHIEVA 1995-96 PONTIAC SUNFIRE 1996 PONTIAC GRAND AM

THIS BULLETIN REVISES THE STEERING WHEEL REMOVAL PROCEDURES IN SECTION 3F-7 OF THE J-CAR SERVICE MANUAL AND SECTION 3F-9 OF THE N-CAR SERVICE MANUAL.

STEERING WHEEL -

REMOVAL:

1. DISABLE SIR SYSTEM. REFER TO "DISABLING THE SIR SYSTEM" IN SECTION 3F.

2. INFLATOR MODULE (2) SCREWS AND ELECTRICAL CONNECTION.

3. INFLATOR MODULE AND HORN CONNECTION.

4. NUT.

5. STEERING WHEEL USING J-1859-03 OR BT-61-9.

INSTALL:

1. ALIGN MARK ON STEERING WHEEL WITH MARK ON SHAFT, THEN INSTALL STEERING WHEEL.

2. STEERING WHEEL NUT.

3. TIGHTEN STEERING WHEEL NUT TO 41 N.M (30 LB FT).

4. INFLATOR MODULE AND HORN LEAD.

5. TIGHTEN INFLATOR MODULE TO STEERING WHEEL SCREWS TO 10 N.M (90 LB IN).

- STAYING WELL AWAY FROM THE INFLATOR MODULES, TURN IGNITION SWITCH TO "RUN" AND VERIFY THAT THE "AIR BAG" INDICATOR FLASHES SEVEN TIMES AND THEN TURNS "OFF". IF IT DOES NOT OPERATE AS DESCRIBED, PERFORM THE "SIR DIAGNOSTIC SYSTEM CHECK" IN THIS SECTION.

6. ENABLE SIR SYSTEM. REFER TO "ENABLING THE SIR SYSTEM" IN SECTION 3F.

FIGURES: 00 ATTACHMENTS: 00

GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.