GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 1996 🢒 Riviera 🢒 Engine 🢒 Engine Mechanical - 3.8L 🢒 Oil Level Sensor

Removal Procedure
  1. Raise the vehicle. Suitably support the vehicle. Refer to Section 0A
  2. Drain the engine oil.
  3. Disconnect the electrical connector.

    4. Object Number: 35861 Size: SH
  4. Remove the oil level sensor.

Installation Procedure

    Object Number: 35861 Size: SH
  1. Install the oil level sensor.

    2. Tighten
    Tighten the sensor to 22 N·m (16 lb ft).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Connect the electrical connector.
  3. Lower the vehicle.
  4. Refill the engine oil.