For 1990-2009 cars only
Removal Procedure
- Remove the negative battery cable.
- Pull back the trunk liner
- Remove the fuel pump control module (1) attaching nut (2).
- Remove the electrical connector (3).
Installation Procedure
- Install the fuel pump control module (1) attaching nut (2).
- Install the electrical connector (3).
- Re-position the trunk liner.
- Install the negative battery cable.
Tighten
Tighten the fuel pump control module attaching nut to 9 N·m
(80 in lb).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
